Joints are an essential part in robotics, especially those that try to emulate the motion of (human) animals. Unlike the average automaton, animals are not outfitted with bearings and similar types of joints, but rather rely sometimes on ball joints and a lot on rolling contact joints (RCJs). These RCJs have the advantage of being part of the skeletal...

If you’re a regular visitor to the Raspberry Pi website and you have a sharp eye, you may have noticed during the last few days a new link has appeared in their footer. Labelled “Investor relations“, it holds links to the documents filed with the London Stock Exchange of their intention to float. In other words, it’s confirmation of their upcoming share...

What did Hackaday Editors Elliot Williams and Al Williams find interesting on Hackaday this week? Well, honestly, all the posts, but they had to pick some to share with you in the podcast below. There’s news about SuperCon 2024, and failing insulin pumps. After a mystery sound, the guys jump into reverbing garden hoses, Z80s, and even ribbon cable repair....

When it comes to famous musicians, Beethoven is likely to hit most top ten charts. Researchers recently peered into his genome to see if they could predict his talent by DNA alone. Using a previously-identified polygenetic index (PGI) for musical talent, which finds the propensity of certain genes to influence a given trait after a genome-wide association...

Researchers at Eset have published a huge report on the Ebury malware/botnet (pdf), and one of the high profile targets of this campaign was part of the kernel.org infrastructure. So on one hand, this isn’t new news, as the initial infection happened back in 2011, and was reported then. On the other hand, according to the new Eset report, four kernel.org...

Just as practical nuclear fusion has been “only 20 years away” for the last 80 years or so, the promise of electrical discharge machining (EDM) in the home shop seems to always be just around the corner. It’s hard to understand why this is so — EDM is electrically and mechanically more complicated than traditional subtractive manufacturing techniques,...