DIY
Found these round caps cut into the bottom the kitchen sink cabinet and bathroom vanities. They’re cut into the bottom of each. Any idea what they are? submitted by /u/AMS911 [link] [comments]
I'm showcasing a supercharged project that’s close to my heart – modding a GMC Sierra power wheels truck for my number one fan and co-pilot, my son Dakarai! We’ve taken this cool ride from basic to beast mode with a bunch of nifty upgrades: - Garmin GPS: Because even young explorers need to navigate the great outdoors. https://www.garmin.com/en-US/p/120959...
My bedroom window won’t open and just spins freely when I put channel locks to it. I bought a new handle and installed, didn’t do anything. Not sure what needs to be done here? It’s not catching anything submitted by /u/sharkseazon [link] [comments]
Hi everyone, I'm preparing to install new engineered hardwood flooring and need some advice on leveling the floor. The manufacturer’s guidelines state that any unevenness must not exceed ±3 mm over every 2 meters. After using a laser level, I discovered that the floor's lowest point is at 3 inches and the highest at 6 inches. Online sources recommend...
Where the drain spouts are on each side would you cut the deck to allow for drainage or leave it? It is discoloring the wood. Also, would composite decking (TREX) discolor like that over time? Or are there other options? submitted by /u/estrellahunter [link] [comments]
Which is better? Forced rust using different chemicals or raw? I used Jasper stones for the eyes. Thoughts? submitted by /u/kythometalcraft [link] [comments]
Costruisci il tuo feed di notizie
Pronto a fare un tentativo?
Inizia una prova di 14 giorni, nessuna carta di credito richiesta.